Powering ahead lol

Looking good after sanding the fret markers. It was a lot easier than I thought it would be. I'm now down to some 1200 sandpaper just to give the finish a fine polish.
Ooooohhhh shiny.  

I got around to cutting the cavity with the jigsaw. Now to sand the  cuts flat, and cut some recesses for the tuners to go into. ATM the sides thickness is over 16mm and ideally and according to Mr Daniel Hulbert 12mm or 1/2inch is preferable.

.

If you notice, the uke is leaning against two cylinders, one is a pepper container the other is a spice container both will be used to wrap sandpaper around for sanding the inside :-)